ePTFE IP68/IP67 Waterproof Vent Plug for Automotive Lamps
short description:
PRODUCT NAME： Plug-In Vent Cap
PRODUCT MODEL ：AYN-Vent Cap_Gray_TT80S20
PRODUCT DIAGRAM ：
MEMBRANE MODEL ：AYN-TT80S20
PRODUCT DIMENSION ：
| H1 H2 ID OD |
12.2±0.2mm; 14±0.05mm; 7.6±0.2mm; 17.2±0.2mm; |
| PHYSICAL PROPERTIES | TEST METHOD | UNIT | TYPICAL DATA |
| Cap Color | / | / | Gray |
| Cap Material | / | / | PP |
| Plug Color | / | / | Black |
| Plug Material | / | / | TPE |
| Plug Hardness | ISO 7619-1 | Shore-A | 60~70 |
| Membrane construction | / | / | PTFE/PET non-woven |
| Membrane Surface Property | / | / | Hydrophobic |
| Typical Air Flow Rate | ASTM D737 |
ml/min @ 7KPa
（ml/min @ 1KPa）
（ml/min/cm2 @ 1KPa）
|
8000
( 1300) (2800) |
| Water Entry Pressure | ASTM D751 | KPa dwell 30 sec | ≥20 |
| IP GradeIP |
IEC 60529
|
/ |
IP65/IP66
|
| Moisture Vapor Transmission | ASTM E96 |
g/m2/24h
|
>5000
|
| Service Temperature | IEC 60068-2- 14 | C | -40 ℃ ~ 125 ℃ |
| ROHS | IEC 62321 | / | Meet ROHS Requirements |
| PFOA & PFOS | US EPA 3550C & US EPA 8321B | / | / |
Changing harsh environmental conditions cause seals to fail and allow contaminants to damage automotive lamps. AYN® Plug-in vent cap could effectively equalize pressure and reduce condensation in lamps’ sealed enclosures, while keeping out solid and liquid contaminants. It can increase the safety, reliability and service life of Automotive lamps.
Shelf life is five years from the date of receipt for this product as long as this product is stored in its original packaging in an environment below 80° F (27°C) and 60% RH.
All data above are typical data for the membrane raw material, for reference only, and should not be used as special data foroutgoing quality control.
All technical information and advice given here is based on Aynuo’s previous experiences and test results. Aynuo gives this information to the best of its knowledge, but assumes no legal responsibility. Customers are asked to check the suitability and usability in the specific application, since the performance of the product can only be judged when all necessary operating data are available.
